 |
 |
Alternative Attachment Methods
To hide track behind eaves (Not possible on all eaves) to reduce visibility of track.
| Step 1. |
Drill 3 1/4” holes in one side of each section of track at the locations where the screws would normally go.
|
| Step 2. |
Drill 3 3/32” holes in the opposite side of each section of track in direct alignment with the 1/4” holes.
|
| Step 3. |
Complete installation as previously described.
|
On surfaces such as stucco or brick, track attachment will normally require the use of glues or adhesives, such as “Liquid Nail”.
| Step 1. |
Apply adhesive to top side of track along full length of track. Place track on hanging surface and tape in place with strips of duct tape.
|
| Step 2. |
Proceed to hang remaining track sections as you would using screws.
|
| Step 3. |
Allow adhesive to dry the required time and remove duct tape.
|
|
 |
